What Needs Maintenance on an RV?

Every RV is a house and a vehicle rolled into one, and both halves need regular care. The good news is that most RV maintenance is simple: look, clean, tighten, test. The bad news is that small problems, especially water leaks, turn into big expensive ones if nobody catches them.

Use this guide as a system-by-system checklist. Not every RV has every item. Some have no propane, some have no generator, and trailers don’t have an engine to worry about. Your owner’s manual and the manuals for each appliance always come first, because equipment varies a lot from one model and year to the next. If you are not comfortable working on propane or electrical systems, leave those to a qualified RV technician.

1. Roof, seals and the outside of the RV

Water is an RV’s worst enemy, and most leaks start on the roof. Inspect the roof and all exterior seals several times a year, and after any big storm or a trip under low branches.

  • Check the sealant around vents, skylights, air conditioners, antennas, solar panel mounts, plumbing stacks and the ladder. Look for cracks, gaps or sealant pulling away.
  • Look over the roof covering itself for tears, bubbles or soft spots.
  • Check the front and rear cap seams, corner moldings and trim.
  • Inspect the seals around windows, the entry door and storage bay doors. Make sure the little drain holes in window frames are clear.
  • Look for delamination on the sidewalls: bubbles or waves in fiberglass usually mean water got in behind it.
  • Check the underbelly and frame for damage, rust and gaps where mice and insects can get in.

One important tip: different roofs need different sealants. Using the wrong one can damage the roof or simply not stick, so match the sealant to your roof material.

2. Slide-outs, awnings and steps

  • Clean and inspect the rubber seals around each slide. Dry, cracked or torn seals let in water and drafts.
  • Clear leaves and debris off slide roofs before bringing them in.
  • Watch and listen as slides move. Grinding, jerking or one side moving faster than the other is a sign to have it checked.
  • Check awning fabric for tears and mildew, and look over the arms and mounting points. Let a wet awning dry before storing it.
  • Keep entry steps clean and check the pivot points and, on power steps, the motor and wiring.
  • Check leveling jacks, stabilizers and the tongue jack or landing gear for leaks, rust and loose bolts.

Slide and leveling systems differ a great deal between manufacturers. Some need lubrication and some specifically should not be lubricated, so follow the manual for your system.

3. Fresh water and the water heater

  • Sanitize the fresh water tank and lines at the start of each season, or if the water starts to smell or taste off.
  • Replace water filter cartridges on the schedule the filter maker recommends.
  • Clean the screen at the city water inlet and check its check valve. Always use a pressure regulator on campground water.
  • Listen to the water pump. If it cycles on and off when no faucet is open, you have a leak somewhere.
  • Look under sinks and behind access panels for drips and water stains.
  • Drain and flush the water heater regularly. Steel tanks, like Suburban, use an anode rod that should be checked and replaced when it’s mostly eaten away. Aluminum tanks, like Atwood, don’t use one.
  • Tankless water heaters need their inlet screens cleaned and may need descaling, especially if you camp where the water is hard.

Winterizing: If your RV will sit where it freezes, drain the water system and either blow out the lines with air or fill them with RV antifreeze. Don’t forget the water heater (bypass it first), the ice maker, washer and dishwasher, and the outside shower. Freeze damage is one of the most common and most expensive RV repairs.

4. Holding tanks, toilet and drains

  • Dump the black tank when it’s at least two-thirds full, so there is enough liquid to carry the solids out. Dump black first, then gray, so the gray water rinses the hose.
  • Flush the black tank regularly with a tank flush or tank wand to keep the sensors reading correctly.
  • Check the dump valves for leaks and smooth operation, and keep the caps and gaskets in good shape.
  • Inspect the toilet seal and keep it lubricated with a product made for RV toilets. Use only tank chemicals your toilet maker approves.
  • Replace a sewer hose that’s cracked or stiff before it fails at the worst possible moment.
  • Check sink and shower traps, and the flexible drain lines that move with the slides.

5. Propane system

Propane is safe when the system is in good condition, and dangerous when it isn’t. Have the system leak-tested and the regulator pressure checked by a qualified technician every year. In between, you can:

  • Check the tanks or cylinders for rust, dents and secure mounting. Portable cylinders must be recertified on schedule to be refilled.
  • Inspect the pigtails and hoses for cracks, and replace them if they look worn.
  • Check that the regulator is covered and its vent faces down so water can’t get in.
  • Test the propane detector, and replace it by the date printed on it. Most last about five years.

If you ever smell propane, shut off the tank valves, get everyone out, and don’t flip any switches until the leak is found.

6. Refrigerator, stove and other appliances

  • Absorption refrigerators (the kind that run on propane and electric): keep the outside vent and the area behind it clean and free of bird and insect nests. Have the burner and flue cleaned as the manual recommends. Check the door seals by closing the door on a dollar bill. If it pulls out easily, the seal needs attention.
  • Residential or 12-volt compressor refrigerators: keep the vents and coils clean and check the door seals. These depend on good battery and inverter health when you’re not plugged in.
  • Stove and oven: keep burners clean and check that the flames are blue and even. Make sure the range hood filter is clean and the outside vent flap opens and closes.
  • Microwave: clean the grease filter if it has one, and make sure it’s securely mounted.
  • Washer, dryer and dishwasher: clean the filters and lint screens, check hoses for leaks, and remember to winterize them.

7. Heating, air conditioning and vents

  • Clean or replace the air conditioner’s return-air filters often. A dirty filter is the most common reason an RV air conditioner can’t keep up.
  • Check the AC shroud on the roof for cracks, and keep the condenser coils clean.
  • Keep the furnace’s outside intake and exhaust clear of nests and debris. Vacuum the return-air openings and ducts.
  • Hydronic heating systems, like Aqua-Hot, have their own fluid, pumps and burner service. Follow that manual closely.
  • Clean roof vent fans and screens, and check the lids and seals.

8. Electrical system, batteries and solar

  • Inspect the shore power cord and plug. Burn marks, melted spots or a loose fit are warning signs of a dangerous connection.
  • Test GFCI outlets with their test button.
  • Keep battery terminals clean and tight, and the batteries secured. Check the water level only in flooded lead-acid batteries. Sealed AGM and lithium batteries should never be opened.
  • Make sure your converter or inverter/charger is set for the type of battery you have, especially if you’ve switched to lithium.
  • Keep the converter and inverter vents clear so they stay cool.
  • Clean solar panels and check their mounts, wiring and the sealant where the wires enter the roof.
  • Use a surge protector or electrical management system at every campground.

Work inside the breaker panel, the transfer switch or the inverter wiring belongs with a qualified technician.

9. Generator

  • Change the oil and filters on the schedule in the generator’s manual, based on hours of use.
  • Run it regularly with a load on it, such as the air conditioner. Most manufacturers recommend exercising it monthly, because generators that sit unused develop fuel and starting problems.
  • Check the exhaust system for leaks, rust and secure mounting. Never run a generator if the exhaust is damaged, and keep the carbon monoxide detector working.
  • Keep a log of the hours. It helps with service, and it helps a buyer trust the RV if you ever sell it.

A fluid analysis of the generator’s oil and coolant can spot wear before it becomes a breakdown.

10. Tires, wheels, bearings and brakes

  • Check tire pressure before every trip, when the tires are cold. A tire pressure monitoring system makes this easy and warns you on the road.
  • Look for cracks in the sidewalls, uneven wear and bulges. RV tires usually age out before they wear out. Check the four-digit date code on the sidewall, and plan to replace tires by about five to seven years old no matter how much tread is left. Don’t forget the spare.
  • Check lug nut torque before each trip, and re-check it after the first 10, 25 and 50 miles whenever a wheel has been off.
  • Have wheel bearings inspected and serviced as the axle maker recommends. Some axles have grease fittings and some need the bearings repacked by hand.
  • Check trailer brakes for wear and adjustment, and inspect the wiring to each wheel.
  • Look over the springs, shackles, hangers and bushings for wear and cracks.
  • Test the breakaway switch, and make sure its battery is charged.

11. Hitch and towing equipment

  • Inspect the coupler, ball, spring bars, brackets, pins and clips before each trip. Look for cracks and missing clips.
  • On a fifth wheel, check the hitch jaws and locking handle, keep the hitch plate lubricated, and look for wear on the kingpin.
  • Check the safety chains and the 7-pin plug and cord.
  • If you tow a car behind a motorhome, inspect the tow bar, base plate, safety cables and supplemental braking system.

For more, see our towing equipment and safety guides.

12. Motorhome engine and chassis

If you drive your RV, it also needs regular vehicle maintenance. Follow the chassis maker’s schedule, not just the RV maker’s. That includes:

  • Engine oil, filters, belts and hoses
  • Coolant and the radiator, which can get clogged with bugs and road grime
  • Transmission fluid and filters
  • Brakes, and on diesel pushers, the air brake system
  • Steering, suspension and alignment
  • The chassis battery, wipers, mirrors, lights and backup camera

Motorhome engines often sit for long stretches, which is hard on them. A fluid analysis of the engine oil, coolant and transmission fluid is an inexpensive way to see what’s going on inside.

13. Safety equipment

  • Test the smoke, carbon monoxide and propane detectors monthly, and replace each one by its expiration date.
  • Check that each fire extinguisher’s gauge is in the green and that it’s mounted where you can grab it. A towable needs at least one 5 BC extinguisher, and a motorized RV or any RV with a generator needs at least one 10 BC.
  • Open each emergency exit window to make sure it works and nothing blocks it.

14. Inside the coach

  • Tighten loose cabinet hinges, drawer slides and latches. Everything in an RV gets shaken on the road.
  • Lift the mattress now and then to check for condensation and mildew underneath.
  • Look inside the bottoms of cabinets and closets for water stains, which are an early sign of a leak.
  • Watch for signs of mice and insects, and seal any openings you find.

Keep a maintenance log

Write down what you did and when: roof checks, tire dates, generator hours, oil changes, sealant work. A simple notebook works fine. It keeps you on schedule, helps a technician diagnose problems, and when it’s time to sell, a buyer will pay more for an RV with a record of good care.

Buying a used RV? An RV inspection checks all of these systems before you sign. Have a question about your own rig? Ask John.

This article is for general information. Always follow your owner’s manual and the instructions for each appliance and component in your RV.